But don t soak cane any longer than 15 minutes or it will start to deteriorate and discolor. Periodically replace the soaked cane strands with new ones in the water so you constantly have a supply ready and waiting.
Make sure to seal the ends of the trim with a bit of the glue so they don t fray.
How to cane a chair back. At the inside back trace the opening left by the removed cane with a fine point marker. Place the cane piece squarely on the chair opening. Use clamps around the edge of the chair to hold the spline in place for at last 24 hours until it dries.
Simply lay down a thin bead of hot glue over your staple line and smooth the trim over the border. Use an x acto knife or razor blade to cut the cane as short as possible. Start at the top center of the chair and work your way around.
The outside back is the back with the. However if the look of cane is what you want it s fairly simple to replace the surface with pre woven cane and your cane back chair will be good as new. Jul 13 2014 explore amy etten s board cane back chairs on pinterest.
Remove a few strands of chair cane from the hank and loosely coil them in a dishpan of warm water to soak for about ten minutes. The easiest way around the damage is to rip it out and replace it with webbing and upholstery. A cane chair repair job is often the only way to salvage these vintage pieces.
If your cane chair needs a little more sprucing up you can add wood stain or a fresh coat of paint. Tape newsprint to the chair s outside back with low tack masking tape. Soaking makes the caning material pliant and easy to work with.
You can use a hammer and wood block to tap it into place if needed. Finish up by weaving the cane from the back edge to the front. We don t want the ends of the cane showing through the back of the chair.
Thread the cane through the chair from the center to the right side then from the center to the left. Begin wedging the cane into the groove on the front center of the chair move to the back center to get it anchored down. Clean out the groove sand the edges if necessary.
After removing the cane hold the foam against the frame and use a permanent marker to trace the shape of the back. Soak the cane sheets in warm water for an hour. Break the bond of the old glue so you can easily lift the spline out of the groove.
If you re looking for a unique and attractive chair for your home office or front porch caning a chair is a great option. Cut around both edges of the old spline on the chair with a utility knife. After you ve traced the foam use the carving knife to cut on the line.
This chair took about 5 1 2 yards of trim. See more ideas about cane back chairs chair makeover redo furniture. Soak the pre woven cane for about 30 minutes or so.
Cane Back Chair Redo More Dining Chair Makeover Dining Chairs Chair Makeover